Point drainage on suspended timber floors - Fundo Ligno
Floor-level shower systems
In addition to the integrated version, the wedi Fundo Ligno floor element can also be installed on the suspended timber floor. The height-adjusting wedi building boards are also used in this installation prozess, which is just as simple as the previous ones. Here, the joins are sealed with wedi 610.
Cut out the timber beam position in the drain pot area and remove the insulating material underneath.
Build framework (35 x 35 cm) in the drain area ...
... and check that the drain is secure.
Close all the openings as far as the drain pot opening using boards.
Fill the recess with earth-moist screed.
Prime the entire timber floor.
Insert the O-ring into the plastic frame' s groove from above and tighten the screw valve of the shower tray using sealing insert.
Apply tile adhesive all over the underside of the shower element.
Check the drain position of the wedi Fundo Ligno element and adapt it, if necessary.
Weight the element down for 24 hours.
Fill the remaining area with 20 mm wedi building boards. The joints can be sealed either with wedi 610...
... or with the wedi sealing tape.
Bring the drain frame to the height of the top tile edge and secure in the bed of adhessive.
If the tile is thicker than 15 mm, use the ramping element to adjust the height.
Tile the element. Insert the shower insert and odour trap.
Insert the stainless steel grid. The siphon can be cleaned at any time.