With the modular wedi Moltoromo system, versatile wall configurations can be created effectively for different bathroom and wellness applications. Round shapes, angled solutions or curved lines, for example, can be installed quickly and easily.
Step 1Pre-drill the holes for the mechanical fixings (diameter: 6 mm).
Step 2For connection to the wall, vertically attach the wall and door fixingset by using mechanical fixings.
Step 3If a door is to be fastened, wedi 610 adhesive sealant is applied onto the wall and door fixing set ...
Step 4... and then the wall and door fixing set is bonded and reinforced with wedi Tools reinforcement tape.
Step 5An installation block is inserted on the floor to stabilise the Moltoromo wall elements. The installation block is positioned in the specified groove in the wall element.
Step 6Before installing the tongue, an evenly applied layer of wedi 610 adhesive sealant is applied in the groove.
Step 7Connection of two Moltoromo wall elements makes it necessary to insert the tongue into the groove before the glue has cured. In such case, the bottom of the tongue rests on the installation block.
Step 8To mount the following elements on the already installed tongue, their grooves should also be coated with wedi 610 adhesive sealant first.
Step 10Check vertical position and alignment of the wall elements by using a spirit level.
Step 11Use slope wedges to compensate floor irregularities or slopes e.g. with Fundo floor elements. Slope wedges can be easily cut to the required size by using a knife.
Step 12Close the open joint by using wedi 610 adhesive sealant.
Step 13Further wall elements can be installed individually using the same principle (steps 5 – 10).
Step 14Before tiling, joints between boards are covered with selfadhesive wedi Tools reinforcement tape.
Step 15The straight wall created by the wall and follow-on element may not be more than 1.20 m long.
Step 16Then, direction should be changed by using an angular or round wall element.
Step 17Place the next element, e.g. a supply element.
Step 18Finally, the Moltoromo wall elements can be individually tiled.
Step 19Fittings etc. can be attached onto or into the wall elements with supply well.