The Sanoasa loungers stand out due to their original and unique shapes. They set individual accents in wellness areas in a variety of styles and designs and can be harmoniously integrated into the total room concept. Upon request, all loungers are available with integrated heating (hot-water or electric heating). All loungers with electric heating offer two thermostat options: AEG 900 (flush-mount thermostat) and AEG 300 (rail-mount thermostat).
Step 1Apply a contact layer of tile adhesive onto the full floor area of the lounger, and then apply adhesive (alternative: wedi Joint sealant).
Step 2Place lounger into correct position and press it into the adhesive.
Step 3Apply wedi Tools reinforcement tape at the lounger's transition areas to the substructure; apply tile adhesive.
Step 4Perform bonding of lounger to the floor areas similar to bonding of one-part loungers (see 1). Then, glue the lie-down surface to the substructure using tile adhesive (alternative: wedi Joint sealant). For this, apply the adhesive as a contact layer first covering the full area; then, distribute the adhesive all over the surface.
Step 5Then, reinforce the transitions between substructure and lie-down surface by using tile adhesive and wedi Tools reinforcement tape.
Special features of Sanoasa Wellness Lounger no. 4: different surfaces
Step 1aApply plaster, tiles or similar to the substructure up to the marking.
Step 2aApply tile adhesive or wedi Joint sealant to the bonding surface.