wedi Fundo design showers consist of a floor element and the appropriate separation walls. They are manufactured from the wedi building board base material and are equipped with a fitted and sealed floor drain (vertical or horizontal), a supplementary waterproof coating and a predefined slope. The installation instructions are stated below, taking Fundo Trollo as an example.
Step 1When installing the floor element, care must be taken in order to ensure that it is mounted adjacent to the wall.
Step 2Apply wedi 610 adhesive sealant in waves onto the cut-out; then, place the individual wall elements into this cut-out.
Step 3The wall elements are connected by a tongue and groove process using wedi 610 adhesive sealant, which is applied to the groove and on the left and right sides of the tongue.
Step 4Then, the wall elements are installed one after the other in accordance with the installation instructions.
Step 5Apply wedi Tools reinforcement tape to the inside and outside of the joints.
Step 6Seal the transition of the shower walls to the inside of the floor board by using wedi 610 adhesive sealant.
Step 7Optional height increase by using the extension element is possible. Apply wedi 610 adhesive sealant and wedi Tools reinforcement tape.
Step 8Due to the absence of any installation ducts, siting of the unit should always be made with a load bearing wall behind to support any fixtures of fittings made.
Step 9Then, tile as normal and install any desired fittings and shower rod, through the board into the load bearing wall behind.