Building of shower wall Fundo Trollo libero / Nautilo libero
Building of shower wall wedi Fundo design shower
wedi Fundo design showers consist of a floor element and the appropriate separation walls. They are manufactured from the wedi building board base material and are equipped with a fitted and sealed floor drain (vertical or horizontal), a supplementary waterproof coating and a predefined slope. The version Fundo Trollo libero differs from Fundo Trollo by the reinforced back element for attachment of fittings and shower attachments. This also allows for isolated placement. The installation instructions are stated below, taking Fundo Trollo libero as an example.
Step 1Due to the integrated installation ducts, siting of the unit can be made anywhere within the room.
Step 2When installing the floor elements, the cold and hot water inlet pipes should be allocated as per the installation plan.
Step 3Apply wedi 610 adhesive sealant in waves onto the cut-out; then, place the individual wall elements into this cut-out.
Step 4The wall elements are connected by a tongue and groove process using wedi 610 adhesive sealant, which is applied to the groove and on the left and right sides of the tongue.
Step 5Then, the wall elements are installed one after the other in accordance with the installation instructions.
Step 6aFlush-mounted fittings: fasten and connect inlet pipes behind the posterior reinforcement board by using drywall screws.
Step 6bSurface-mount fittings: fasten wall boards to the posterior reinforcement board, and install suitable tap extension, if required.
Step 7Cut holes for fittings in the cover panel and glue into place.
Step 8aVersion Fundo Trollo libero, flush-mounted fittings: Seal holes with wedi 610 adhesive sealant and suitable wedi Tools sealing collars.
Step 8bSurface-mount fittings: Seal as with inlet pipe cut-outs.
Step 9Apply wedi Tools reinforcement tape to the inside and outside of the joints.
Step 10Seal the transition of the shower walls to the inside of the floor board by using wedi 610 adhesive sealant.
Step 11Optional height increase by using the extension element is possible. Apply wedi 610 adhesive sealant and wedi Tools reinforcement tape.
Step 12Then, tile as normal and install any desired fittings and shower rod at the reinforced wall element, if applicable.